Screwdriving and Riveting Assembly - Articles - Page 11

Simple Test Determines Cause of Loose Fasteners

The type of loosening affecting a bolted joint can be determined by examining the position of the torque stripe after testing and retightening

Jon D. Ness

October 8, 2020

Bolted joints are widely used to assemble components. That is not surprising, since they are cost effective while being relatively easy to assemble and disassemble.

Five Tips to Take Control of Your Fastening Process

Jeff Lowe

October 8, 2020

Here are five ways manufacturers can simplify the fastening process and make an assembler’s life easier.

2020 Assembly Plant of the Year: There’s No Looking Back at Murakami

The Campbellsville, KY, plant excels at continuous improvement and workforce development

Austin Weber

October 6, 2020

Every motorist uses rearview mirrors whenever they get behind the wheel. In fact, most people look at them every few seconds as they drive. However, few ever give those ubiquitous devices much thought.

Clinching for Electrical Assemblies

The Tox Joining process can be used to make durable, electrically conductive connections in electrical products.

Troy Waldherr

September 4, 2020

Since its introduction to automotive manufacturing in the mid-1980s, the Tox clinching process has captured hundreds of different applications.

MasterCraft Purchases FL Plant to Establish Dedicated Manufacturing Facility

August 24, 2020

MERRITT ISLAND, FL— MasterCraft Boat Company announced it has purchased a boat manufacturing plant located here that will be dedicated to manufacturing the new Aviara brand.

Loctite 243 is a medium-strength threadlocker that performs well on 0.25- to 0.75-inch-wide fasteners in high-vibration envi-ronments, such as motors. Photo courtesy Henkel Corp.

Securing Bolted Joints With Threadlockers

Whether pre-applied or applied on the assembly line, threadlockers keep fasteners tight, and immune to vibration and failure

Jim Camillo

August 4, 2020

Lubricity is more than a just a cool word. It is the slipperiness needed on a fastener to achieve controlled torque during assembly. A wide variety of lubricants are specifically designed for this purpose, ranging from beeswax polish and anti-seize grease, to silicone spray.

Automatic Installation of Nonthreaded Fasteners

Numerous systems and workcells help manufacturers accurately install pins, clips and other nonthreaded fasteners.

Jim Camillo

July 20, 2020

There are no unimportant or unnecessary parts in an assembly. Each component within a product, be it large or small, simple or complex, has been delegated there by an engineer to perform a specific task.

Five Things: Assembly Fasteners

June 18, 2020

SPIROL has introduced a new series of molded-in inserts for plastic assemblies. The rugged design of the Series 63 through-hole inserts and Series 65 blind-end inserts

What’s New With Cordless Tools

Today’s industrial-grade cordless tools combine higher torque and greater accuracy with advanced data-gathering capabilities

Jim Camillo

June 10, 2020

Few technologies achieve widespread manufacturing acceptance in their original form. Most require some sort of modification before they begin to be regularly used on an assembly line.

High-Speed Rail Demands Light Railcars

Carbon-fiber composite is on track for big growth in the rail sector

Austin Weber

June 9, 2020

Automotive and aerospace manufacturers have been at the forefront of the lightweighting trend for some time now. But, they're not the only ones. The railway industry could also benefit from the use of new, lightweight structural materials.