Medical Devices Assembly

RSS

The impact of COVID-19 on this country didn’t need to be this bad. It shouldn’t have been this bad. But this is what happens when a country turns its back on manufacturing. America traded its independence for short-term corporate profits, and recovery is going to take much more than a few trillion dollars in federal emergency loans. A euthanized industrial base can’t magically be brought back to life.

GEORGETOWN, KY — Engineers at the TILT Lab at Toyota's assembly plant here have joined in the fight against COVID-19.

GASTONIA, NC — North Carolina officials announced that chemical manufacturer Dymax Corp. will establish a new production facility outside Charlotte.

IRVINE, CA — BIOLASE Inc. announced that it expects to partner with MEKICS Co. Ltd, an intensive care unit (ICU) equipment manufacturer, to supply ICU-grade portable ventilator through BIOLASE's FDA-registered manufacturing facility in California.

GUELPH, Canada — Danby, a Canadian appliance manufacturer, is retooling its production lines to make full-service ventilators and a second device that allows bag valve masks to operate mechanically in an emergency situation.

With so many ways to formulate plastic to get just the right combination of color, texture, strength and durability, it’s easy to forget how the parts will be assembled. However, if the parts will be assembled with screws, overlooking such parameters as thread style, driver speed and boss design could spell disaster on the assembly line.

Laser welding of plastic parts creates precise, high-quality, particulate-free joints for medical devices, consumer products and other assemblies. However, for the process to work, the laser light must pass through the top part to be absorbed by the bottom part. Welding a clear plastic part to another clear plastic part was not possible.